Standard flashings

 

1. Ridge

b1

2. Ridge with a square top

b5

3. Verge

b7

4. Classic verge

b12

5. Transition

b24

6. Window sill

b28

7. Window sill without top edge

b29

8. Window sill with turned-up edges

b30

9. Classic and standing seam eaves flashing

b27

10. Eaves flashing

b26

11. Valley

b10

12. Drip flashing

b11

13. External corner

b15

14. Internal corner

b16

15. Parapet capping

b20

16. Cover strip

b22

Roof flashings

Flashings are sheet metal bends for roofs that give the roof details a technically correct and neat finish. They are used at the ridge, eaves, verges, transitions, corners, parapets and other roof joints, protecting the roof from moisture, wind and precipitation.

Adjusting dimensions and configuration

The dimensions, angles and bend configuration of all standard flashings can be changed to suit a specific roofing and the technical requirements of the project. The range of flashings is not limited to the sheet metal bends shown on this page – other solutions are also available to suit the project.

Colours and coatings

Roof flashings are available in different colours to match the roofing and facade. You can see the choice of colours in the colour chart section:

Colour chart →

Depending on the chosen material and coating, flashings are made in the corresponding metal thickness. Different coatings are available, including Polyester, Pural BT, Pural BT Matt, Matt POL, PVDF and PVC, giving a long life and protection from the environment.

Flashings to an individual drawing

If a specific solution is needed, flashings can be made to your drawing and dimensions. In that case, please submit your technical drawing and specification here:

Flashings to your drawing →

Choosing and adjusting the flashings correctly is essential for the technical integrity of the roof system, safe use and a consistent architectural look.