Fixing screws for the Classic roof profile

EASYFIX fixing screws for the Classic roof profile – 4.2 × 25 mm, C4, TORX20

EASYFIX 4.2 × 25 mm fixing screws are designed for fixing Classic roof sheets to a timber substructure. The sharp point allows screwing without pre-drilling, the low-profile head gives a wide bearing area on the sheet surface, and corrosion class C4 ensures long-term durability outdoors. Packed 500 pcs, TORX20 drive.


Installation instructions

Screws are fixed in the centre of the sheet fixing hole. Pay particular attention to how tight they are – screws that are overtightened prevent the thermal expansion of the sheet and can cause deformation. The screws must be in a straight line, so that the sheets can be joined and fixed without problems along their whole length.

Recommended tool: a cordless screwdriver with a TORX20 bit. Too high a torque can damage the sheet coating around the screw head.


Main properties

  • Size: 4.2 × 25 mm
  • Head type: Low profile (Modified Wafer Head) – large bearing area on the sheet surface
  • Point: Sharp point – screwing without pre-drilling
  • Drive: TORX20
  • Corrosion class: C4 – suitable for outdoor use
  • Standard: EN14566
  • Packaging: 500 pcs – smaller quantities also available as needed
  • Manufacturer: Taiwan

Use

The screws are designed for fixing Classic profile roof sheets to timber battens or a rafter substructure. They are also suitable for other profiled metal roofing where the standard size is 4.2 × 25 mm and C4 corrosion protection is needed.


Need help choosing screws?

Contact our specialists or browse our full range of roofing screws.

Contact our sales team →
View all roofing screws →


Depending on the batten spacing and the roof structure, an average of 5–7 screws per 1 m² are needed. A standard pack contains 500 pcs, enough for about 70–100 m² of roof. The screws can be bought in any quantity – you do not have to buy a full pack. The exact quantity needed is best worked out from the fixing pattern of the specific project.

C4 is a high corrosion resistance class under EN ISO 12944, meaning suitability for outdoor use in moderately aggressive environments – including coastal regions with salty air and industrial areas. For Classic roofs, where the sheets last 30–50 years, C4 screws are the minimum recommended requirement.

A TORX bit transfers force to the screw better, because the contact area is larger than with cross-head bits. This means less chance of the bit slipping and damaging the screw head or the sheet surface. Especially important when working with a cordless screwdriver at height.

Yes – 4.2 × 25 mm is a standard size used by many profiled metal roofing products. However, before using them on other profiles we recommend checking the manufacturer’s installation instructions, as some roofing may specify particular screw parameters.

Tighten the screw so that the head presses firmly against the sheet, but the sheet is not compressed or deformed. Overtightened screws block the thermal expansion of the sheet, which can cause waviness or damage to the sheet. We recommend setting the screwdriver to a medium torque and checking the first screw visually.