Double-threaded screw for downpipe fixing

Double-threaded fixing screw for downpipes – M8, wood and metric thread, TX, zinc plated

Marcopol SDM-D-TX/6 is a double-threaded fixing screw with a wood thread at one end and an M8 metric thread at the other. It is designed for fixing downpipe brackets to the wall – the wood-thread end screws into a plug set in the wall, while the M8 metric end protrudes and allows the bracket to be fixed with nuts. The screw is driven with a TX bit, and the knurled section in the middle stops it from turning once in place. Available in three lengths – 100, 160 and 200 mm. Packed 100 pcs, can be bought in any quantity.

A suitable wall plug for these screws is available from us separately.


Main properties

  • Type: Double-threaded screw – wood thread + M8 metric thread
  • Available lengths: 100 mm / 160 mm / 200 mm
  • Metric thread: M8
  • Driving: TX bit
  • Coating: Zinc plated (ZN), white
  • Packaging: 100 pcs – smaller quantities also available as needed
  • Manufacturer: Marcopol, Poland

How installation works

  1. Drill a hole in the wall and insert the plug
  2. Drive the wood-thread end into the plug with a TX bit – the knurled middle section locks the screw
  3. The M8 metric thread protrudes from the wall
  4. Fix the downpipe bracket

Need help choosing fixings?

Contact our specialists – we will help you choose the right length and a suitable wall plug.

Contact our sales team →
View all roofing screws and rivets →


Choose the length according to the thickness of the wall finish and the desired distance between the downpipe and the wall. The 100 mm length suits smooth walls where the downpipe is close to the wall. The 160 and 200 mm versions are needed when there is a larger gap between the wall and the pipe – for example when the wall has a finishing layer or facade cladding.

A suitable wall plug is available from us separately – contact our sales team for a specific recommendation depending on the wall material (brick, concrete, aerated concrete blocks, etc.).

The knurled (pressed) middle section stops the screw from turning once it has been driven in. This lets you fit the bracket and tighten the nuts without having to hold the screw end with a spanner.

M8 metric thread – standard M8 nuts need a 13 mm spanner.

Yes – we sell them in any quantity. You do not have to buy a full pack.