Roofing screws 4.8 x 50 mm

ETANCO roofing screws – 4.8 × 50 mm, GT F2, 12 Dura Zinc, painted

ETANCO GT F2 4.8 × 50 mm are self-drilling roofing screws with a hex head and a steel washer with EPDM seal, designed for fixing profiled metal roof sheets to a timber substructure. This is the most versatile length in the GT F2 range – 50 mm is needed when fixing through the crest of the profile, so that the screw clears the profile height and goes deep enough into the timber battens. Available in many RAL colours to match the shade of your roofing. Packed 100 pcs, but can be bought in any quantity.


Main properties

  • Size: 4.8 × 50 mm
  • Type: GT F2 – self-drilling, no pre-drilling needed
  • Head type: Hex head with steel washer and EPDM seal
  • Material: Hardened steel, zinc plated – 12 Dura Zinc (min. 12 µm)
  • Colour: Available in many RAL colours
  • Corrosion class: C1–C3
  • Standard: ETA-12/0580
  • Packaging: 100 pcs – smaller quantities also available as needed
  • Manufacturer: ETANCO, Poland

Use

GT F2 4.8 × 50 mm is the most commonly used length when fixing through the crest – the screw has to clear the profile height before it reaches the timber battens. A 28 mm screw is too short in such cases, while 70 mm is usually not needed for standard metal sheets.

The EPDM seal gives a watertight joint at the fixing point. The screws are self-drilling – no pre-drilling needed. Recommended tool: a cordless screwdriver with a hex bit.


The screws are available in many RAL colours – to match the shade of your roofing!

Contact our specialists about available colours and quantities.

Contact our sales team →
View all roofing screws and rivets →


When fixing through the crest, both the washer and the full profile height sit between the screw head and the timber battens. A standard 28 mm screw is too short in this case to go deep enough into the timber. The 50 mm length clears the profile height and gives sufficient penetration into the battens.

All three are from the same GT F2 range with identical heads and coating. 28 mm is for standard fixing through the sheet fixing holes. 50 mm is needed when fixing through the crest – the most common case where the standard length is not enough. 70 mm is for special cases, for example when there is a layer of insulation or other additional material under the sheet.

GT F2 4.8 × 50 mm screws are available in a wide range of RAL colours. Contact our sales team about available colours – we will help you find the right match for your roof.

Yes – we sell the screws in any quantity. You do not have to buy a full pack.

No – GT F2 are self-drilling screws. A cordless screwdriver with a hex bit is enough. Given the 50 mm length, a sufficiently powerful screwdriver is recommended.