Standing seam clip fixing screws

ESSVE Outdoor screws for fixing standing seam clips – 3.9 × 30 mm, C4, PH2

ESSVE Drywall Outdoor 3.9 × 30 mm are self-drilling screws with a flat head and CorrSeal coating, which gives corrosion class C4 for outdoor use. Toode recommends these screws for fixing standing seam clips – 3 screws per sliding clip, 2 screws per fixed clip. The flat head stays at surface level and does not drill through, which is important for the clip to sit firmly and correctly. Packed 1000 pcs, but the screws can be bought in any quantity.


Main properties

  • Size: 3.9 × 30 mm
  • Head type: Flat head – stays on the surface, does not sink in
  • Drive: PH2 (Phillips 2)
  • Coating: CorrSeal – corrosion class C4, suitable for outdoor use
  • Material: Hardened steel
  • Drilling capacity: Steel up to 0.9 mm, timber – no pre-drilling
  • Packaging: 1000 pcs – smaller quantities also available as needed
  • Manufacturer: ESSVE, Sweden

Use

The screws are designed for fixing standing seam clips to timber battens or a steel substructure. Number of screws per clip:

  • Sliding clip – 3 screws per clip
  • Fixed clip – 2 screws per clip

The CorrSeal coating gives long-lasting corrosion resistance outdoors – important where clips and screws may be exposed to moisture and condensation. The screws are self-drilling – no pre-drilling needed.


Need help working out the number of screws for your roof?

Contact our specialists or browse our full range of roofing screws.

Contact our sales team →
View all roofing screws and rivets →


A sliding clip needs 3 screws, a fixed clip 2 screws. A pack of 1000 screws is enough for about 330 sliding or 500 fixed clips. The exact quantity can be worked out from the total number of clips on your roof.

CorrSeal is a coating developed by ESSVE that gives corrosion resistance class C4 – suitable for outdoor use even in more aggressive environments, including coastal regions with salty air. For standing seam roofs, where the screws are exposed to moisture, class C4 is the minimum recommended requirement.

When fixing a clip, it is important that the screw head presses the clip firmly against the substructure. If the head sank in too deep, the clip could be loosely fixed or deformed. We recommend setting the screwdriver to a sufficient, but not too high, torque.

Yes – we sell the screws in any quantity. You do not have to buy a full pack.

No – the screws are self-drilling and suitable for both timber and steel substructures up to 0.9 mm thick. A cordless screwdriver with a PH2 bit is enough.